EK-Loop D-RGB LED magnetic strip (600 mm)-an independent 600 mm long D-RGB LED strip, EK-Loop D-RGB LED magnetic strip (4 x 400 mm)-a set of 4 D-can chrysanthemums Chain-connected RGB LED strip and EK-Loop D-RGB LED edge diffuser strip (500 mm)-White-a special LED strip with side lighting through a diffuser. 

EK-Loop D-RGB LED magnetic stripe (600 mm) This LED magnetic stripe is connected to the PC motherboard or D-RGB controller through a standard 3-pin 5V connector (+5V, data, blocking, ground). Its density is 54 LEDs/m, and there are a total of 33 individually controllable LEDs on its 600 mm long light bar. The main form of mounting it on the PC case is through magnets, but it also has a secondary option, which can be taped on any flat surface. It is used by removing the protective foil from the back of the strip. The light strip is wrapped in a high-quality silicone shell, which can improve the light uniformity and protect the light strip. EK-Loop D-RGB LED Magnetic Kit (4 pcs of 400 mm) The LED kit is connected to the PC motherboard or D-RGB controller through a standard 3-pin 5V connector (+5V, data, shield, ground). Its density is 51 LEDs/m, and there are a total of 21 individually controllable LEDs on each of the four 400 mm long light bars. These light strips can be connected in a daisy chain, which means you can connect multiple LED light strips to get an extra-long lighting solution. The strips in the kit are connected to each other through JST-SM connectors. The main form of mounting it on the PC case is through magnets, but it also has a secondary option, which can be taped on any flat surface. It is used by removing the protective foil from the back of the strip. The light strip is wrapped in a high-quality silicone shell, which can improve the uniformity of light and protect them. EK-Loop D-RGB LED edge diffuser light strip (500 mm)-white This LED light strip has side lighting through the diffuser. It can be used for more concentrated applications when you want to illuminate in a specific location and serve as a detail light. It uses addressable RGB diodes, allowing full control of each diode individually. It is connected to the PC motherboard or D-RGB controller through a standard 3-pin 5V connector (+5V, data, blocking, ground). Installation is achieved through adhesive double-sided tape. D-RGB lighting control EK-Loop D-RGB LED magnetic products are compatible with the popular RGB synchronization technology of all major motherboard manufacturers. The arrow mark on the 3-pin D-RGB LED connector must be aligned with the +5V mark on the D-RGB (addressable) connector. Availability and pricing EK-Loop D-RGB LED strips and EK-Loop D-RGB LED kits are manufactured in China and can be ordered through the EK online store and a dedicated dealer network.